Abstract:
Objective Coal gasification slag is a bulk solid waste produced by the coal gasification process, which has become a prominent bottleneck restricting the high-quality development of the modern coal chemical industry. Flotation of coal gasification slag is a prerequisite for its resource utilization. Method Grinding and flotation tests were conducted on coal gasification fine slag from a coal chemical enterprise in Inner Mongolia to analyze the effects of raw material physical properties, grinding method, and grinding time on the grinding-flotation de-ash effect of the samples. Result&Conclusion The ash fraction of coarse and fine particles of the sample was demarcated, so the classification was carried out with 0.125 mm as the boundary before selection, and the coarse particle carbon fraction was recovered in advance. In addition, it was found through the grinding test that the grinding efficiency of wet ball milling was significantly higher than that of rod milling, and it could obtain higher carbon and ash dissociation and lower grinding fineness under the same grinding time. Still, it was also prone to the phenomenon of over-grinding. The flotation test proved that grinding can significantly improve the effect of flotation de-ashification of gasification fine slag, in the best condition ball milling 4 min, flotation refinement, and combustible body recovery was 60.58% and 78.26%, respectively, and can get a low ash concentrate product with ash content of 39.15%, to achieve the flotation de-ashification of gasification fine slag.